A new bottom.
Attic stairs trimming bottom section to length.
Step 5 check to make sure the stairs fit flush with the floor and that all joints are tight with no gaps fig.
9 trim them again.
And standard ceiling openings of 22 5 in.
Nail the trim into the door jamb of the attic stairs by driving the 4d nails through the bottom of the trim where it is thinner it should make contact with the jamb frame of the attic stairs.
Press down on the climbing section to insure that the power arms are fully extended.
Pull down the folding attic stairs.
Trim bottom section to length using wood saw.
Built for safety this sturdy wood ladder makes it easy to access your attic with nine non slip steps and a convenient handrail for support while climbing.
Install rubber tread to bottom ends of rail using 1 screws provided.
Fold the bottom section of ladder out of the way.
The werner wood universal fit attic ladder features the werner wood universal fit attic ladder features a 250 lb.
D transfer these dimensions to the bottom section of the ladders right and left rails and draw a cutting line between the two points.
Each section of the ladder has 2 different positions to catch onto the other section so you might need to experiment to find the best height for your attic.
Do not use the folding attic ladder.
A gap like this could also result from a bottom section that has not been properly trimmed to fit.
Step 4 cut each bottom stringer to the proper length along the lines drawn.
Weight capacity designed to fit ceiling heights from 8 ft.
If the stairs are too long fig.
Fold open the top two sections but keep the final section folded up.
Push down on the top and second joints to make sure the stairs are extended properly.
During the installation process depending on your floor to floor height you might have needed to install additional stops.
Don t nail into the ceiling joists just yet that steps comes last once all four pieces have been loosely installed.
Use a straightedge and a tape measure to measure the length needed for the bottom section measuring at both sides of each ladder rail to find the angle for the bottom ends of the rails.
Greenville pa 724.
Metal folding stair model 2200 werner co.
Photo by kolin smith where to find it.
Transfer cut length dimensions from table 4 to the bottom section of the ladder right and left rails and draw a cutting line between the two points.
Mark and cut the bottom section of the ladder cutting the rails at an angle to match the floor.
Trimming bottom section to length see figure 5.
Drill 1 16 pilot holes.