Attic Ladder Too Long

If the attic ladder looks like figure 10 then both of the legs are too long and need to be trimmed further.

Attic ladder too long.

Pull the stairs down until the hinges are extended image 1. Check and tighten all bolts on the stringers and make sure the jamb is stoutly anchored as described below. Basic space requirements for an attic ladder. Pull down the folding attic stairs.

A sure sign that something is sagging putting excessive strain on the hinges. From inside the attic check for obstructions when the door is closed check shims installation cords to make sure nothing is interfering with the door shutting properly. Fold open the top two sections but keep the final section folded up. Full size attic ladders usually need an opening in the ceiling that is at least 22 1 2 x 54 inches.

The louisville ladders have opening dimensions of 22 5 by 54 inches it has a ceiling height that will fit 7 foot 8 inch up to 10 foot 3 inch ceilings and has a step depth which will fit even the customers with the broadest stepping depth it goes to 3 25 inches. Do not extend the legs to the floor yet. Looking for a space adequate to this opening is your first step. Check the springs or struts of your ladder and make sure they are working correctly.

As stated the trapdoor is spring loaded to enable it to pull itself back up when pushed. A gap like this could also result from a bottom section that has not been properly trimmed to fit. Louisville ladder aa2210 sturdy and durable attic ladders. Make sure you have someone helping from the garage level so you don t get stuck in the attic.

Place attic assembly on supports. If pull down attic stairs have already been installed or you have taken the time to install them you should be aware of some of the problems associated with the design. Push down on the top and second joints to make sure the stairs are extended properly and. Photo by kolin smith.

7 ladder too long or too short attic ladders are not engineered to hang free at the bottom and should not be used if the bottom stiles are not angle cut to securely bear on the floor. Common problems with pull down stairs. If the attic ladder looks like figure 8 then both of the legs are too short and the attic ladder is not safe to use. Measure the width of the ladder you want to install and mark a rectangle on the ceiling.

You should know that it is made to be sturdy and safe since it. A new lower section would need to be purchased from the manufacturer. The ladder is divided into three sections. Also make sure there is a suitable landing space in the attic so you can safely mount and dismount the ladder while carrying items.