But it held on for dear life.
Attaching a ledger board to a house with siding.
Gap between the end of the ledger and the ends of siding and fill it with high quality exterior caulk to keep water from leaking behind the ends of the ledger.
Make the outline large enough to include space for the deck boards on top the ledger and any trim boards on the sides.
Cut away the marked area of siding with tin snips.
Instead cut off a section of siding so ledger can be in complete contact with house.
In order to install the ledger board you usually need to remove the house s siding.
Well not acutally attaching to the siding but to a house with t1 11 siding.
Step 2 cut away the vinyl siding carefully cut away the siding with a utility knife braced along the edge of the carpenter s square to avoid slicing through the house wrap.
I was concerned about rot hiding behind the ledger.
The really weak areas was on the other side of the deck.
Snap a chalk line cut out the siding and tack up the ledger board.
Never install a ledger board over the top of siding no matter what you hear this can weaken the connection.
Step 3 add 2 x 8 planks between joists.
Anchor deck joists to the ledger with joist hangers filling each hole with galvanized joist hanger nails rated for pressure treated wood.
Next snap a chalk line across the siding the same length of the board.
Make sure to install flashing under the siding extending over the ledger the flashing prevents the build up of moisture which causes rotting.
Here are the steps to take when installing a ledger on a home with siding.
Avoid cutting the house wrap beneath.
Using a 4 foot level check to make sure the line is straight.
Start by making an outline on the siding where you want to position the ledger board.
How to attach a ledger board to a vinyl sided house.
These 18 articles will teach you how to install flashing and bolt the ledger connection to the house rim.
Aluminum and vinyl siding can easily be removed with tin snips from an area one foot surrounding the ledger board location.
Properly installing a ledger board for your deck is one of the most important structural components of building a safe and strong deck.
Measure the length and width of your deck to attach the ledger correctly.
Measure the exact width and length of the ledger board with a tape measure.
Then slip flashing behind the siding covering the top edge of the ledger.
Locate the rim joist and mark an outline on the siding where you want to position the ledger board using a tape measure pencil and chalk line.
