Attach Awning To Brick

Always attach awning to structural wall behind the veneer.

Attach awning to brick.

Depending on your brand of awning you will use either a large bolt or a screw to attach the awning into the brackets. If you just put screws into the mortar it will eventually crumble around the entrance hole and just pull out. You can t just nail or glue something to bare brick. Awnings need approximately 6 to 12 inches of open heightwise wall or roof space to be installed.

Since the 4 brick had 2 air the anchors were cantilevered 6. Attaching heavy objects to brick is more difficult than mounting on wood or drywall. I would never consider attaching awning to brick veneer. Before you proceed check the brick for hardness if the brick is easily dimpled by applying pressure to the surface with a screwdriver or other sharp tool use the same mounting procedure as a cement siding installation to avoid the brick crumbling or pulling out under the weight of the awning.

Specialized drill bits are required to bore through the brick and concrete sleeve anchors are needed to expand inside the brick and act as sturdy durable supports. Wall space needed for attaching. Faux stucco or metal buildings with no backer material. Smart awnings with sensors.

Less than a minute. Fasten the awning bar to the brackets. Also when using screws it s imperative that you use countersinks for the screws. Retractable awnings retract or unfurl in less than a minute by hand or automatically via remote control wall switch smartphone tablet timer or key switch.

Attach the hardware through the brackets and over the awning bar to hold it in place.